Category: Embedded Development

Ethetnet Switch Hat

I just received HLP-7688A module and looking at the size I must admit that I tempted to create a Switch/Router in Hat format. I am not os sure about the SPI on this, but it has 2 UART’s, so assuming I can control the code on the Linux module this could be interesting with Wifi…

Read the full article

Plain as Shell language

I am slowly getting the SW stack for BasicPI together and wonder if I should implement a minimal shell language based on Plain. I can regardless run a Plain appliction at start-up for configuration, but a shell language means that we are able to connect on a CLI console and write/execute scripts and commands ad-hoc…

Read the full article

China win again!

In my previous post I mentioned that I lacked doc – I notified the seller and a few hours later I got it – thank you. The doc was actually available on the net, but in 9 of 10 times I contact Asian sellers they actually respond quick and with care. Well done!

alStream

A MCU like STM32F405 have multiple serial devices and though their hardware is very different they perform the same job of sending/receiving ino. alStream is a base class for all components with a serial stream interface like USB, UART, CAN, SPI, I2C and even UDP/Ethernet. The objective is to provide a uniform messaging service where…

Read the full article

BasicPI Firmware Stack

This illustrates the BasicPI Firmware Stack in progress. What I always do in embedded applications is to make a “standard” main.cpp as follows: void AppInit() {    // wire hardware } int main() {    AppInit();    // start OS } A team I worked in years ago agreed on this standard so we should…

Read the full article

Linux Ethernet Switch/Router Hat

The most obvious Hat to use HLK-7688A on is a Ethernet Switch or Router with SPI backbone support. I have ordered a dev unit so I can test out this possibility. The Ethernet switch part is very straight forward, I also see a very decent SPI, but I need to dig a bit more into…

Read the full article

The Age of Linux

Linux started seeing a serious increased usage in embedded projects with raspberry PI due to it’s availability and low cost. And the last years have provided a large number of low cost embedded Linux solutions. They are getting smaller, more powerfully and decreasing in cost making them very attractive in projects. Raspberry PI might still…

Read the full article

STCubeIDE Review 2

I have struggled a little to find an IDE I was OK with, but finally settled with STCubeIDE or Eclipse as it actually is. This is IMO one of the smarter moves that ST have done to support their MCU’s. The editor is “ok”, it compiles, download allow you to debug multiple targets + I…

Read the full article

DSO150 Oscilloscope Annotated

DSO150 is very easy to use and operate like a multi-meter, and this caught my attention because the other Oscilloscopes I havve needs to be set up. DSO150 is basically only to switch on and use like a Multi-meter – you instantly see the signal and it was surprisingly easy to operate the HMI. I…

Read the full article