My first choise for a MCU for the I2C/SPI Adapter card was STM32F042F6 since I have 4 of these in my stock, but buying these now is a nightmare. Looking at MCU’s I really would like to use STM32G0B1KE, but price difference between ST and Digikey is a 3 x. so what I decided to…
My next module is a TOF sensor that detect distance to objects, but those modules are based on I2C and I might need some distance between detector and PLC, so I have 2 options. I can move a PLC module close to the I2C device or I can use a separate RS485/CAN Interface. It sound…
I want to add TVS or Photo couplers to the PowerServoe and looking at the PCB lanes above you can see it is only five lanes crossing from left to right and I have plenty of space. All the caps are leftovers from PWM3 and can be partly removed if needed. This one is easy…
I decided to go with a Power Key, meaning the motherboard will provide 24V, 12V and 6-8V on 3 separate pins. The module then decide what power it need by pin usage as illustrated below. The top image is my Power Servo Controller, while the lower one is PWM3. If a module need to select…
This is a 2 x Power Servo module I just made based on the PWM3. The circuit is very similar except I removed the DRV8313 and 3 of the current sensors. Controlling a servo is about sending a pulse at 50Hz between 500uS to 1500uS – and I have some 60Kg Servoes that can drain…
I have just made both these boards, but strugled far more to route the PWM3 board than Ethernet board – looking at the two I got a bit surpriced – On the top board (Ethernet) you can see the same infrastructure components as on the bottom outlined – the top has an extra SPX3819 and…
86 components on 25 x 45 mm – it don’t look like much in 3D, but it was actually quite hard to route even on 4 layers. MCU STM32G491RE DRV8313 for 3 x PWM 4 x Current Sensors 1 x DC Input Sensor 1 x CAN-FD Tranceiver (IPC) 1 x RS485 Tranceiver (IPC) 32Kb FRAM…
Showing 3D of the 3 x PWM Module. I had to reduce Voltage to 24V due to capacitors, but 12V or 24V should be ok. I added a 2-pin header for PWM Voltage and a capacitor bank as well as the 4 current sensors. The TSOP28 has a PAD so the middle of the top…
This is the 3D from a 4 module motherboard. I originally planned to use standad 90mm wide boxes, meaning that the motherboard probably needed to be 86 – 88mm wide, but this draft is 91mm wide. It means I will have issues using standard 90mm low cost wide boxes, but 2,5 mm is a lot…
Using a PLC module (or any component) in BSA is straight forward – you simply declare an UML State symbol with the input/output events you need and set this as external with the selected interface protocol and addressing scheme. The protocol can be anything because BSA is after all just a visual specification, so the…